|
Specifications: 6 cylinder 4 stroke-cycle diesel
Bore: 4.33in (110mm)
Stroke: 5.0in (127mm) Displacement: 439 cu in (7.2L)
Aspiration: Air-to-Air
cooling Compression ratio: 16:1 AMA Rating for USA Tax
Purposes: 40.94hp Rotation
(from flywheel to end): Counterclockwise Capacity for
Liquids:
- Cooling systems (engine only): 3.5 US gal (13.2 L)
- Lube Oil System (refill): 5.25 US gal (20.0 L) Weight
Net Dry (approx -
including flywheel): 1275 lb (579kg)
Performance Data: (190hp / 250 hp
versions): Rated: 190hp (142kW)
/ 250hp (187kW) Rated rpm: 2200 Governed Speed rpm:
2500/2400 Low Idle rpm:
700 Operating Range(rpm): 1060/960 Altitude Capability:
7500ft (2287m) Peak
Torque: 520 lb-ft (705N-m) / 660 lb-ft (898N-m) Peak
Torque rpm: 1440 Torque
rise (%- governed rpm): 30 / 21
Electronic Features:
- Electronically controlled full diesel backup
operation
- Electronic self-diagnostics
- Compatible with Caterpillar electronic technician
electronic control analyzer
programmer and MPSI Pro-Link service tools
- Cold weather startup strategy and electronic idle
control functions
- ECM storage of operational maintenance and diagnostic
data
- Customer selectable reprogrammable operational
parameters:
- Engine Monitoring system
- Cruise control with exclusive SoftCruise
- Vehicle speed (mph & km/h) limiting and
protection
- Idle shutdown timer and override
- Maintenance monitor (miles km or hours)
- Customer password protection
- Exhaust brake operational modes
- Adjustable low idle rpm
- Programmable Power Take-Off (PTO) functions:
- Adjustable speed control of vehicle while in
PTO mode
- Adjustable maximum engine rpm speed
- Adjustable minimum engine rpm speed
- Limit engine torque to driven equipment
- Adjustable ramp rate up or down from PTO set
speed
- Adjustable rpm " bump" rate
- Selectable PTO configuration for " in
cab" or station of
remote operation
Dimensions: Height: 36.5in (927mm) Length: 42.8
in (1086mm) Width: 26.5in
(674 mm)
Standard Equipment:
- Air inlet manifold heater
- Cooling belt-driven jacket water pump oil cooler
- Crankcase breather
- Dipstick
- Electronic Control Module (ECM)
- Electronic Data Link ATA/SAE
- Electronically controlled multiport gas injectors
- Flywheel and SAE No.2 housing
- Fuel spin-on filter transfer pump
- Governor - full range electronically controlled
- Hydraulic Electronic Unit Injection System
- Lifting Eyes
- Lubricating spin-on filter pump front or rear sump
pan
- Natural gas fuel module for LNG or CNG including
regulator filter and shut-off
valve
- Turbocharger
- Vibration Damper
Accessory Equipment:
- Air Compressor gear driven 13.2 cfm
(0.37m3/min) or 16.5 cfm
(0.37m3/min) with gear driven pump drive
- Air inlet elbow
- Alternator 12 Volt 115 Amperes 21SI and drive
- Block Heater 1000 Ampere
- Coolant conditioners
- Exhaust adapters
- Fan drives
- Front PTO adapter
- Front support
- Hydraulic pump drive SAE A or SAE B
- Turbocharger compressor outlet elbow
- Starting motor 12 volt
|